Miele Washer F63 Errormdallcsd
Miele Washer Error E63 is the error that indicates defective water path system.
- Symptom: The Water Intake LED flashes. The water intake valves are closed and the program is interrupted. The Drain Pump is activated for 120 seconds.
- Possible causes: Faulty Water Path Control System. The Control Power Module cannot register a valid position from the the Water Path Control Unit within about 80 seconds of it being switched on.
- The Water Path Control System uses a single Cold Water Valve that opens during all needs for cold-water. The incoming cold water supply is routed to the Dispenser Assembly where a distributor tube (driven by a geared synchronous motor) sends the water to the appropriate dispenser. The position of the distributor tube is monitored by the Electronic via several contacts within the Water Path Control System Unit. If the Control Module does not detect a valid position approximately 80 seconds after the water path system is switched on it displays the F63 error.
- Solution: Check the Water Path Control Unit. If malfunctioned, replace the water path assembly.
Miele Appliance Repair San Diego (619)339-5682 | (858)208-3549 | (949)432-0720
Disclaimer: The Technical Reference Materials (hereinafter “Materials”) at this site are intended for viewing and use by qualified appliance service technicians. If you do not possess sufficient mechanical and electrical skills and the ability to comprehend, understand and follow all safety warnings and cautions on the product in these Materials, do not attempt to undertake the repairs that are depicted in these Materials. MD Appliance LLC disclaims any and all liability, to the fullest extent permitted by law, arising out of your use of the site and Materials.