Reset the Water Filter Light on Miele Refrigerator
This article will show you how to reset the Filter light after you replace the water filter on your Miele refrigerator . The water filter should be replaced after a certain amount of time (approximately every 6 months). It also depends on the water usage. Filter replacement notification occurs in 2 stages.
Stage 1: After 23 weeks of runtime or 665 gallons (2520 liters) of water the filter icon in the display will turn red. Stage 2: If the filter is not replaced, the filter icon will blink after 26 weeks or 739 gallons (2800 liters) of water.
You can confirm Filter replacement in a few different ways:
Easy Way: Press and hold the Thermometer and the Filter touchpad or the freezer’s Up and On/Off touchpad for approximately five seconds (mostly on new models).
Using Customer Service Mode:
- Switch the freezer ON
- Locate and hold the Down arrow
- Turn off the display by pressing the Thermometer touchpad.
- While holding the Down arrow press the Thermometer touchpad. When it becomes yellow release it.
- Keep holding the Down arrow until letter C shows up on the display. Scroll down to h and press thermometer icon. Scroll down to h2 and hold it until h- shows up.
- Press Thermometer. When letter h shows up scroll back to C and then press Thermometer again.
Miele Appliance Repair San Diego
(619)339-5682 | (858)208-3549 | (949)432-0720
Disclaimer: The Technical Reference Materials (hereinafter “Materials”) at this site are intended for viewing and use by qualified appliance service technicians. If you do not possess sufficient mechanical and electrical skills and the ability to comprehend, understand and follow all safety warnings and cautions on the product in these Materials, do not attempt to undertake the repairs that are depicted in these Materials. MD Appliance LLC disclaims any and all liability, to the fullest extent permitted by law, arising out of your use of the site and Materials.
Leave a Reply
You must be logged in to post a comment.